Click picture to see larger one
(Please wait while loading...large page)
This is the engine and front wiring harness.
It needs to be installed. Any volunteers?
Not
quite done
Small change in pace, New U-Joints installed
Drive shaft is installed
Transmission is filled with ATF
Front bumper is installed as the new inner
fender wells did not have holes in them to accommodate the wiring
harness for the front and side turn signal/marker lights.
I was going to wait to paint
these until I did the radiator
tray so I might as well do these at the same time
Core support project, but I have to paint the
battery
